If a tower has a history of tray deck damage due to pressure surge or high liquid level, the mechanical integrity of the trays should be upgraded. This is done by the use of shear clips, as shown in Fig. 8.4. The use of shear clips is not the best way to improve the mechanical integrity of trays but it is the only effective method to use during a turnaround, when no other plans have been made to mechanically upgrade the tray decks and time is short.
Underneath the tray, where the tray panels are bolted together, there is a narrow vertical strip of steel which is called the integral truss. This truss is not connected to the tray ring. Referring to Fig. 8.4, a small steel bar (4 in by 2 in by 0.25 in) is welded or bolted to the end of the integral truss. This bar is the shear clip which is inserted underneath the tray ring. (Do not weld the shear clip to the tray ring.) When an upward surge of vapor pushes the tray up, the force is transmitted along the length of the integral truss, through the shear clip, to the tray ring, and thus to the vessel wall. Many large diameter towers will already have shear clips. But if your inspection indicates they are not present and tray failure has been a problem, the installation of shear clips is the way to go for three reasons:
• The job can usually be done in 24 hours, while other tower work continues.
• The shear clips can be cut from ordinary 0.25 in carbon steel plate.
• Experience proves they are effective in resisting moderate pressure surges.